.
.
.
.
To get the EnginePlus lifters well lubricated I take the flexion wave in my hand for a case improvement. To get more oil on the right case half I enlarged the oil channel behind the middle cam bearing about 50%.
During the provement of the case I saw rough edges at the centre selvedge. For better air flow inside the case I machined it.
I use the M8 head strud washers and the wrench size 15mm M8 Nuts for the crank case bolting (like Gene Berg in the good old days). I found 1,5 mm diameter reduction on Günters lathe to get a better fitment.
.
.
.
Keine Kommentare:
Kommentar veröffentlichen